A. A newly connected AP can be booted in FlexConnect mode.
B. When an AP is changed from Local mode to FlexConnect mode, a reboot is required.
C. Enhanced FlexConnect mode allows to enable wIPS on FlexConnect APs.
D. When an AP is changed from Local mode to FlexConnect mode, reboot is not required.
E. Using CCKM with FlexConnect APs requires the use of FlexConnect Groups.
F. FlexConnect was previously know as "H-TEEP"
Answer: DE
You are troubleshooting location accuracy problems on a customer deployment. You have done the wireless design and you are sure that the As are correctly placed on the Cisco Prime map. Everything is correctly synchronized between WLC, PI, and MSE but, you are sometimes getting elements tracked on the wrong floor. After you get this debug output from MSE, which step is next?
A. Reduce the confidence level on MSE when the last heard value is higher than 150 seconds.
B. Run a new calibration model and ensure that it is applied on the floor.
C. Discard RSSI values lower than – 75 dbm.
D. Check it the AP with MAC address 001c 0f 4c 45 60 is physically located on the floor where the element was wrongly located and if the inter-floor attenuation is weak.
Answer: C
